What was meant to happen?
We were suppose to pass the Pre-line inspection.
What did happen?
Well the inspector came an did his inspection for the insulation of the house and found that there some places, very little places that didn't have any insulation in that area. And we failed the inspection because of that.
Why did it happen ?
This happened because straight after we finished putting in the insulation we thought we were ready for our inspection without going around to check if all the holes and gaps were filled in. This is what we should of done but instead we ended calling for an inspection.
What did we do to fix it?
After we got the details from the inspector on what we had failed in the inspection we went around the house searching for holes that needed to be filled in. Even the tiniest gap you could see had to be filled in.
It wasn't that much of a problem, it was just a little mistake of not double checking to see if we had filled every gap for all walls. I reckoned it would've been a better idea to double check the whole house first before assuming that the insulation was awesome. At least now we know what to do now that we have already been through what would happen if you fail next time we'll double check the walls before proceeding on... =)
Recent Comments